Predator Help for 2004 A4
Thread Starter
Heel & Toe
Joined: Sep 2003
Posts: 17
Likes: 0
From: Fort Lupton CO
Predator Help for 2004 A4
I have been trying to install my Predator performance tune into my 2004 A4 for a week now. I have two issues that Diablo is working on but no luck yet.
1) With the performance tune installed, I can't "Modify Parameters" as you are supposed to be able to. Diablo claims it works on the bench. They also say I am doing everything right as far as the install is concerned.
2) I'm in Denver with an altitude of 5300ft. The drag strip is at 5800ft. With the Predator tune installed, there is absolutely no difference in ETs or MPH from the factory tune.
Anybody with a Predator tune for a 2004 have any ideas? The Diablo experts are stumped so I though I would try to Corvette Forum experts.
Al
1) With the performance tune installed, I can't "Modify Parameters" as you are supposed to be able to. Diablo claims it works on the bench. They also say I am doing everything right as far as the install is concerned.
2) I'm in Denver with an altitude of 5300ft. The drag strip is at 5800ft. With the Predator tune installed, there is absolutely no difference in ETs or MPH from the factory tune.
Anybody with a Predator tune for a 2004 have any ideas? The Diablo experts are stumped so I though I would try to Corvette Forum experts.
Al
Instructor
Joined: Jul 2004
Posts: 168
Likes: 0
From: Metairie La.
If the performance tune is installed in your unit, you can modify the tune by using SET PERAMETERS. This will allow you to change a/f ratio, fans, and all other items under pages 8 & 9 in the manual. This will change settings +/- from the performance tune only.
Thread Starter
Heel & Toe
Joined: Sep 2003
Posts: 17
Likes: 0
From: Fort Lupton CO
Debmwb,
This is a brand new Predator.
Ruler89,
I don't have selective Ride Control, but I pulled the fuse anyway at Diablo's request. No change. It still says I can't modify parameters.
Thanks, Al
This is a brand new Predator.
Ruler89,
I don't have selective Ride Control, but I pulled the fuse anyway at Diablo's request. No change. It still says I can't modify parameters.
Thanks, Al
