How much HP with this set up?
Thread Starter
Safety Car
Joined: Jul 2005
Posts: 4,205
Likes: 2
From: Chicago-NW Burbs Illinois
How much HP with this set up?
I have an A4 with Dynatech long tubes, x-pipe, and hi flow cats, with corsa indy exhaust, and vortex rammer intake. if i get a good tune, what can i expect on the dyno to the wheels. thanks
Intermediate
Joined: Sep 2005
Posts: 47
Likes: 0
From: Buffalo NY
Originally Posted by WKMCD
Might be as high as 335
look at it this way right now as my vette sits with the cheap dual cone intake and a cat back borla stinger setup i put 323.4 down at the rear wheels.
hope that helps some
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Melting Slicks
Joined: Nov 2003
Posts: 2,555
Likes: 5
From: Fredericksburg VA
Every car is different and don't be disappointed if it comes in low. I've seen numbers as low as in the 250WHP range on a bone stock A4.
Mine is an M6 and when I dyno'ed the original motor with a Volant CAI and Borla XR1 Catback, it only made 296WHP/ 301#torque.
I'd read a lot of claims on here before hand and it was quite disappointing to get those numbers...
Then I installed LGM LTs with SLP high flow cats, Xpipe and stingers, along with an LS6 intake and ported Tbody and laid down 335WHP/355#torque at the wheels with a LS1 Edit tune.
The new motor combo disappointed yet again. Forged bottom end, TR 224/224 114LSA cam, Ported 98 model LS1 heads with 2.02/1.57 Valves and all the other mods... It made 375WHP/ 370#torque with an LS1 Edit tune.
Shoot low and be pleasently surprised!
Mike
Mine is an M6 and when I dyno'ed the original motor with a Volant CAI and Borla XR1 Catback, it only made 296WHP/ 301#torque.
I'd read a lot of claims on here before hand and it was quite disappointing to get those numbers...
Then I installed LGM LTs with SLP high flow cats, Xpipe and stingers, along with an LS6 intake and ported Tbody and laid down 335WHP/355#torque at the wheels with a LS1 Edit tune.
The new motor combo disappointed yet again. Forged bottom end, TR 224/224 114LSA cam, Ported 98 model LS1 heads with 2.02/1.57 Valves and all the other mods... It made 375WHP/ 370#torque with an LS1 Edit tune.
Shoot low and be pleasently surprised!
Mike