MAF ends question
Thread Starter
Racer
Joined: Nov 2005
Posts: 482
Likes: 0
MAF ends question
I just purchased Tbryne MAF ends and i have been hearing that these will lean out the car because they have no screen and they inside is few mm bigger in diameter than a stock MAF....is this true??? I do have a Vinci VHP tuner, so cant i just add 5 or 10% more fuel to fix this problem???
Any info will help.....
-Clay (2000 C5 A4 with 3.15 rear gear)
Any info will help.....
-Clay (2000 C5 A4 with 3.15 rear gear)
Melting Slicks
Joined: Jul 2004
Posts: 3,092
Likes: 120
From: orlando florida
St. Jude Donor '15
depends on how rich/lean you are to start off with. back when i installed the vinci MAF ends on the wife's car, the o2 readings were in the 980mV range. once installed and redyno'ed the same day. they went to 890-910mV. this translates to about 13:1 a/f ratio. to answer your question,yes, you can add 5% 10% power enrichment to offset the lean condition that might arise when you install the MAF ends.
