Blown Head Gasket!
Thread Starter
3rd Gear
Joined: Jun 2006
Posts: 3
Likes: 0
Blown Head Gasket!
Have a '95 coupe -- C-4, small block LT-1 (350/300) -- with blown head gasket.
Would appreciate recommendation of a shop in the Houston (or surrounding) area. Reputable and ... reasonably priced, if possible.
Anyone have a ballpark figure of $ to replace gaskets only vs "mill" heads and replace gaskets?
Thanks!
Would appreciate recommendation of a shop in the Houston (or surrounding) area. Reputable and ... reasonably priced, if possible.
Anyone have a ballpark figure of $ to replace gaskets only vs "mill" heads and replace gaskets?
Thanks!
Advanced
Joined: May 2006
Posts: 78
Likes: 0
From: SoCal
I know there are shops that do both C4 and C5, but you might have better luck posting this in C4 General.
Pro
Joined: Sep 2005
Posts: 669
Likes: 0
From: Sugar Land Tx
I would try Corvettes of Houston or Icon Autosports in Stafford. Both of these places work on c4's as well as c5's and c6's. To mill the heads your looking at around $100. Check with LME engine builders off the Beltway near Tanner.
HTH
James
HTH
James
