Need An Introduction To Nitrous
Thread Starter
Burning Brakes
Joined: Jan 2005
Posts: 900
Likes: 0
From: New Bern NC
Need An Introduction To Nitrous
I have a 97 w/ a 408. The rings a gapped for nitrous, and I'm starting to consider it. Car puts down 515 RWHP. Not sure how much more power I'm looking for, may be a 150 shot or so. Also not sure about the set up. Everything on the car has been done without compromise, and I'll be looking for the best w/ this nitrous set up. My assumption is that direct port may be the best way to go. Looking forward to the input and suggestions. Thanks! 
-I have posted this in the FI section and haven't had any responce.
-I have posted this in the FI section and haven't had any responce.
Burning Brakes
Joined: Oct 2001
Posts: 1,146
Likes: 0
From: The Internet
Originally Posted by 97Rob
-I have posted this in the FI section and haven't had any responce.
Burning Brakes
Joined: Apr 2006
Posts: 976
Likes: 1
From: Lincoln NE
just stick to the FI section... slower responses over there because there are less users in that section... just give it time... if you need information on demand that just LS1 related and not corvette.. LS1tech might be a better place to place your question.. but you can get some off teh wall answers over there.. 
Pro
Joined: Oct 2004
Posts: 578
Likes: 0
From: Folsom CA
Originally Posted by N0TDADYS_98
just stick to the FI section... slower responses over there because there are less users in that section... just give it time... if you need information on demand that just LS1 related and not corvette.. LS1tech might be a better place to place your question.. but you can get some off teh wall answers over there..
the FI/N20 section here isnt as busy as LS1Tech.com's N20 section. You will get more feedback and faster response there.
