When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Take one or two out and check their condition. Look for oil corrosion or signs of overheating. That can tell you if you should change now or not and it's good preventive maintenance. I changed mine at 30K and went with the AC Delco Irridiums.
Wouldn't hurt to take them out see how they look. Wear isn't going to be an issue at this point but there's no way I'd leave them in for 100k. A bit of anti-seize before you put them back in but make sure you don't get any on the end of the plug as this stuff is conductive and can cause a misfire. What you have to remember is that depending on where you live the quality of fuel can change as well as the additives used in them. This can greatly affect the life of your plugs. The other factor is the mechanical condition of the engine and various components as well as the sensors that control them. Nothing can tell you more about the condition of your engine and how it's running than a spark plug. Yet , they are the least expensive component to replace and something that we can all still do. Why not change those plugs more often and keep your engine running it's best?
Here's the best reason to pull your stock plugs ASAP (probably too late already); the stock plugs have a small puck tacked on that inevitably falls off (guess where it goes? In your cumbustion chamber, that's where), radically increasing the gap.
The plugs the car came with should absolutely be replaced, no question.
Last edited by Dan_the_C5_Man; Nov 20, 2006 at 02:05 PM.
Take one or two out and check their condition. Look for oil corrosion or signs of overheating. That can tell you if you should change now or not and it's good preventive maintenance. I changed mine at 30K and went with the AC Delco Irridiums.
From: Dear Karma, I have a list of people you missed.
St. Jude Donor '08-'09-'10-'11-'12-'13-'14-'15-'16
Originally Posted by Tigershark3
IMHO I would not wait until 100k - They could be a bear to get out and you could strip the threads. Don't forget the anti-seize.
Be sure to wait until the engine is well cooled before removing and do yourself (and your knuckles) a favor by disconnecting and removing the driver's side coil pack as an assembly. One harness plug, four plug wires and five bolts and this is easily done. It will make a huge difference in the amount of room you now have to reach the number seven plug.
HTH,
Robert