Stock throttle body enlargement
Melting Slicks
Joined: Jul 2005
Posts: 2,586
Likes: 2
From: Bardstown Kentucky
I polished mine and I believe the issue with honing it very much is that its not solid. There is a gap between the outside casting and the inside I believe. When you polish it, it does turn out to be somewhat larger but of course in the middle its the same size. You would have to replace the blade in the throttlebody if it was to be honed.
Thread Starter
Racer
Joined: May 2004
Posts: 270
Likes: 0
From: NORFOLK VA.
I polished mine and I believe the issue with honing it very much is that its not solid. There is a gap between the outside casting and the inside I believe. When you polish it, it does turn out to be somewhat larger but of course in the middle its the same size. You would have to replace the blade in the throttlebody if it was to be honed.
Thanks
Tech Contributor
Joined: Dec 1999
Posts: 32,910
Likes: 2,402
From: Anthony TX
CI 6,7,8,9,11 Vet
St. Jude Donor '08
NoooooOOOOOOOoooo!!!!
Its way too thin and you will destroy it! If you arerunning 400 RWHp or less, you do not need to worry about it! if you have 400 + RWHP get an aftermarket intake and a LS2 TB from ValveGod
BC
Its way too thin and you will destroy it! If you arerunning 400 RWHp or less, you do not need to worry about it! if you have 400 + RWHP get an aftermarket intake and a LS2 TB from ValveGodBC
Thread Starter
Racer
Joined: May 2004
Posts: 270
Likes: 0
From: NORFOLK VA.
