Anyone else?
Texas Speed headers
Thread Starter
Le Mans Master
Joined: Feb 2007
Posts: 6,674
Likes: 57
From: Mt Pleasant, TN
Texas Speed headers
Has anyone installed a set of Texas Speed long tube headers? If so how was the fit and finish of them? I am looking to into buying them and want some feedback before I make the purchase. Thanks.
Instructor
Joined: Aug 2005
Posts: 167
Likes: 2
From: Tampa Florida
i have them on my car, they made good power and fit ok but the 02 bungs were welded on a high angle and the 02 sensors hit the tunnel plate so i had to cut a section of the tunnel plate out for clearance
Thread Starter
Le Mans Master
Joined: Feb 2007
Posts: 6,674
Likes: 57
From: Mt Pleasant, TN
Racer
Joined: Oct 2006
Posts: 481
Likes: 26
From: Edmond Oklahoma
Finished the install this week at Extreme Performance in Oklahoma City. The install went great the only problem was that the O2 sensor holes were not quite over far enough and somewhat hit the tunnel plate. Other than that the install went rather smooth, no fitment issues or anything odd. The SOP feeling is defintely there and ran a buddy of mine tonight after the install who is usually dead even with me, to see if there was any difference. I easily pulled on him and quickly gained lengths on him in which I usually was bumper to bumper with him.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski