Removing Stock Catbacks.
Thread Starter
Intermediate
Joined: Nov 2005
Posts: 43
Likes: 0
Removing Stock Catbacks.
Can anyone tell me if the stock catback (flange rearward) can be removed in one piece without cutting? I would like to save the stock system in one piece, however I am not sure if it can be removed intact without cutting a pipe. (Of course, I am actually talking about 2 pieces since each side is separate. ) Thanks for any information rendered.
Team Owner
Joined: Jul 2004
Posts: 24,652
Likes: 298
From: NJ
St. Jude Donor '05-'08
Yes you can remove it without cutting it. You should use a lift because the height needed to lift the rear to get the exhaust out over the axle is dangerous without the proper equipment.
if you do this without a lift make sure you have jack stands for safety. Also you will probably need to add some wood to your jack because most jacks do not have enough extention.
if you do this without a lift make sure you have jack stands for safety. Also you will probably need to add some wood to your jack because most jacks do not have enough extention.
