raising the vette
Thread Starter
Burning Brakes
Joined: Jul 2007
Posts: 864
Likes: 2
From: Jax FL
raising the vette
I also posted this on general forum but I would like to hear just maybe from a couple more of you?
---------------------------------------------------------------------
I have asked part of this question before and you all were very helpful but I need tad bit more guidance.....you'll told me I needed to raise the rear of my vette 36" to swap my stock catback for a ti.cb...my question is do I need to be concerned with the front end being forced down to low?.... 36" is high enough right?
..... I can not use a lift because I need to leave it jacked/blocked up while I get my ti. catback welded back together which will be a differant thread when I am done ( don't cut the ti unless you are a welder) ...and yeah a couple of you'll told me so
thanks for your help!!!
---------------------------------------------------------------------
I have asked part of this question before and you all were very helpful but I need tad bit more guidance.....you'll told me I needed to raise the rear of my vette 36" to swap my stock catback for a ti.cb...my question is do I need to be concerned with the front end being forced down to low?.... 36" is high enough right?
..... I can not use a lift because I need to leave it jacked/blocked up while I get my ti. catback welded back together which will be a differant thread when I am done ( don't cut the ti unless you are a welder) ...and yeah a couple of you'll told me so
thanks for your help!!!
