Belanger Header Install - Studs vs bolts
Thread Starter
Racer
Joined: Feb 2002
Posts: 328
Likes: 0
From: Ijamsville MD
Belanger Header Install - Studs vs bolts
Just got my headers back from Jet Hot. They look sooo good, they MUST get installed. They were on me '01 that became a T1. Anyway, have seen some of the posted installation instructions. I guess these will go in about the same. The question is about studs vs bolts. I have ARP studs that I thought would make life easier relative to the gaskets and holding the headers in place. The question is can you actually use the studs given the cramped quarters. Has anyone done this?
Thanks for any help!
Gary
Thanks for any help!
Gary
Last edited by Wild Horzes; Aug 12, 2008 at 09:25 AM.
