Crap...help.
Thread Starter
Melting Slicks
Joined: Apr 2007
Posts: 2,107
Likes: 4
From: Northern VA
Crap...help.
So i have a borla catback on my Z that's uneven. After i inspected that the muffler hanger bolts had 3 washers on that side and not the other i decided to remove the 2 bolts and remove washers to install and see how level it is with the other side. Ya well i didn't get that far because after i removed the washers to push the exhaust up i knocked the 2 bolts into the frame rail and have no freakin clue how to get them out. I tried a small pen magnet with no luck...what are my options? If i remove the rear bumper and crash support is there enough room to reach in there? Anyone had this happen to them before? Help!
Safety Car
Joined: Feb 2002
Posts: 3,726
Likes: 368
From: Montoursville Pa
So i have a borla catback on my Z that's uneven. After i inspected that the muffler hanger bolts had 3 washers on that side and not the other i decided to remove the 2 bolts and remove washers to install and see how level it is with the other side. Ya well i didn't get that far because after i removed the washers to push the exhaust up i knocked the 2 bolts into the frame rail and have no freakin clue how to get them out. I tried a small pen magnet with no luck...what are my options? If i remove the rear bumper and crash support is there enough room to reach in there? Anyone had this happen to them before? Help!
Thread Starter
Melting Slicks
Joined: Apr 2007
Posts: 2,107
Likes: 4
From: Northern VA
I got it. What a pain in the ***. Was almost pure luck. I also was fishing for 2 bolts at first till i noticed its connected by a plate. Just got it and got my tips aligned perfect. 
