Lifter preload,- Is .080" the midpoint?
Drifting
Joined: Jul 2005
Posts: 1,484
Likes: 27
From: Torrance Calif
I think your about right.
At .003 I think your into margin of error.
When I setup mine (adjustables) instead of preload, I bottom them out (zero lash) then back them off accordingly.
I settled on 0.075 from zero.
Here is a link to a lot more info:
http://www.ls1tech.com/forums/genera...leed-down.html
At .003 I think your into margin of error.
When I setup mine (adjustables) instead of preload, I bottom them out (zero lash) then back them off accordingly.
I settled on 0.075 from zero.
Here is a link to a lot more info:
http://www.ls1tech.com/forums/genera...leed-down.html
Last edited by heavymetals; Mar 28, 2009 at 07:15 PM.
