IPC light out
#1
Heel & Toe
Thread Starter
Member Since: May 2008
Location: Okemos MI
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
IPC light out
Noticed the other night that the light behind the E/M and RESET buttons wasn't lit. Buttons 1-4 do light so I assume it's just a bulb. Was wondering if this is a bulb that can be replaced or if I'll have to replace the whole unit (button module). Also, is there a shortcut to get the button module out? Service manual says I basically have to dismantle the intire dash to get the IPC bezel out.
Last edited by spladam74; 08-22-2009 at 08:27 PM.
#2
Le Mans Master
Member Since: May 2006
Location: DuBois PA
Posts: 5,987
Likes: 0
Received 18 Likes
on
16 Posts
St. Jude Donor '11-'12-'13-'14-'15
Yes it's a single bulb that lights those two buttons, I'm afraid that you will indeed have to remove the IPC to gain access to the rear of the DIC switch.
Good R&R instructions;
http://www.vetteessentials.com/instr...zel_howto.html
Replacement bulb source;
http://www.mcmaster.com/#1505k414/=3b4c93
Good R&R instructions;
http://www.vetteessentials.com/instr...zel_howto.html
Replacement bulb source;
http://www.mcmaster.com/#1505k414/=3b4c93