HB install-help needed
Thread Starter
Burning Brakes
Joined: Dec 2005
Posts: 831
Likes: 2
From: Silver Spring, MD
HB install-help needed
I am not trying to resort to whacking on the balancer but cannot find a suitable install tool from the local shops. i would like to make one like i've seen here on the forum in some posts but cannot find any all thread the correct size. I assume they are made from a piece of M16x2.0 120 mm or longer. Does anyone know where to buy the all thread? No luck at home depot or lowes-they do not carry any metric.
thx
thx
Drifting
Joined: Jan 2008
Posts: 1,722
Likes: 138
From: Florida
St. Jude Donor '09
www.ThomasNet.comSearch ResultsPlaces for fasteners suppliers near Surprise, AZ
Copper State Bolt & Nut Co - Place page
www.copperstate.com - 8936 North 79th Avenue, Peoria - (623) 334-4951
Carson Sales Company Inc - Place page
www.carsonsales.com - 5524 North 51st Avenue, Glendale - (623) 939-1597
Marks Bolts,Nuts and Surplus - 2 reviews - Place page
www.marksbolts.com - 6710 W Belmont Avenue, Glendale - (623) 939-9312
Copper State Bolt & Nut Co - Place page
www.copperstate.com - 17023 N Black Canyon Hwy # 1, Phoenix - (602) 548-1873
Dave's Hardware - 1 review - Place page
www.acehardware.com - 4377 West Bell Road, Glendale / Phoenix - (602) 843-3233
Fastenal - Place page
www.fastenal.com - 701 West Deer Valley Road, Phoenix - (623) 582-2777
Southwest Fastener - Place page
www.swfastener.com - 242 East University Drive, Phoenix - (602) 272-2658
Copper State Bolt & Nut Co - Place page
www.copperstate.com - 8936 North 79th Avenue, Peoria - (623) 334-4951
Carson Sales Company Inc - Place page
www.carsonsales.com - 5524 North 51st Avenue, Glendale - (623) 939-1597
Marks Bolts,Nuts and Surplus - 2 reviews - Place page
www.marksbolts.com - 6710 W Belmont Avenue, Glendale - (623) 939-9312
Copper State Bolt & Nut Co - Place page
www.copperstate.com - 17023 N Black Canyon Hwy # 1, Phoenix - (602) 548-1873
Dave's Hardware - 1 review - Place page
www.acehardware.com - 4377 West Bell Road, Glendale / Phoenix - (602) 843-3233
Fastenal - Place page
www.fastenal.com - 701 West Deer Valley Road, Phoenix - (623) 582-2777
Southwest Fastener - Place page
www.swfastener.com - 242 East University Drive, Phoenix - (602) 272-2658
Tech Contributor
Joined: Jan 2007
Posts: 19,511
Likes: 1,186
From: Dyer, IN
I am not trying to resort to whacking on the balancer but cannot find a suitable install tool from the local shops. i would like to make one like i've seen here on the forum in some posts but cannot find any all thread the correct size. I assume they are made from a piece of M16x2.0 120 mm or longer. Does anyone know where to buy the all thread? No luck at home depot or lowes-they do not carry any metric.
thx
thx
