Front end creaks
Thread Starter
Instructor
Joined: Jun 2006
Posts: 201
Likes: 0
From: Boynton Beach Florida
Front end creaks
My front end on my '01 Z started to make a creaking and popping noise. Upon inspection, I noticed my tie rod ends and tie rods were worn. I just replaced both. The popping noise has stopped, but it still creaks. I am hoping it is just the sway bar bushings. Does anyone have an idea of what it may be? Thanks.
Melting Slicks
Joined: Sep 2006
Posts: 2,736
Likes: 7
From: Redding CA
You're probably in the right area with the sway bar bushings...some guys wrap teflon tape around the sway bar where the actual bushing rides on the sway bar. Try that first and see if it fixes the noise.
Burning Brakes
Joined: Aug 2005
Posts: 772
Likes: 6
From: Huntsville AL
Loosen and remove the two sway bar bushings that hold the sway bar to the bottom of the car. No need to loosen or do anything with the end links.
Remove the bushings, clean and apply grease to the inside and outside of the bushing. Reinstall.
This should solve the problem.
Remove the bushings, clean and apply grease to the inside and outside of the bushing. Reinstall.
This should solve the problem.
Team Owner
Joined: Mar 1999
Posts: 22,025
Likes: 192
From: At the beach in little Rhody
I have used grease on the bushings in the past, but this last time I used the Teflon tape approach after reading of similar issues on some of the Honda and foreign car boards. My front end is now dead quiet and there is no mess. Been in there now for a few years without touching them again.
Melting Slicks
Joined: Sep 2006
Posts: 2,736
Likes: 7
From: Redding CA
I have used grease on the bushings in the past, but this last time I used the Teflon tape approach after reading of similar issues on some of the Honda and foreign car boards. My front end is now dead quiet and there is no mess. Been in there now for a few years without touching them again.
tried the grease...going to teflon this weekend or next week
Race Director
Joined: Mar 2008
Posts: 12,413
Likes: 502
From: Rio Rancho NM
I have used grease on the bushings in the past, but this last time I used the Teflon tape approach after reading of similar issues on some of the Honda and foreign car boards. My front end is now dead quiet and there is no mess. Been in there now for a few years without touching them again.
