Help installing SLP blackwing in 04 Vette

Reply Subscribe

Thread Tools

Search this Thread

Feb 18, 2011 | 01:25 PM

Theos92VR4

Thread Starter

Intermediate

Joined: Aug 2010

Posts: 42

Likes: 0

From: Hackettstown New Jersey

Help installing SLP blackwing in 04 Vette

Whats up guys. I am getting ready to install the blackwing intake in my 04 z51 and have run into a problem. On the filter there are 2 holes one for the AIR system and then one for this plastic plug thing that says GM/Donaldson performance on it. I dont know what it is, but in all of the illustrations it shows this piece in the intake. I tried to put it in before I installed it, but the piece is too big for the hole.. What should I do? I really dont want to drill it out and risk getting the plastic into the filter. Or do I silicone this in? The nipple on it fits in, but the base doesnt. Or can I just say screw it and block off the hole all together?

Thanks for your help guys!

Feb 18, 2011 | 01:40 PM

77BlueL82

Racer

Joined: Oct 2002

Posts: 449

Likes: 2

From: Fayetteville, PA

Hole

Pictures would be nice, but, if it's the part I think it is you may have to ream out the hole to fit the small tube. I'm sure others will chime in.

Feb 18, 2011 | 02:24 PM