Another LS steam port question
Thread Starter
Instructor
Joined: Oct 2013
Posts: 109
Likes: 1
Another LS steam port question
Doing an lq9 Iron block swap using L92 heads.
If I remember right, the factory 6.0 had the steam ports in the rear with the front blocked If I am correct?
I just installed the heads on this block in this configuration, I am confused to whether they are backwards.
I was unaware they would not interchange from left to the right. I worked on SBC to long, this is my first LS engine.
I am using the LS3 intake.
Needing some ideas.
If I remember right, the factory 6.0 had the steam ports in the rear with the front blocked If I am correct?
I just installed the heads on this block in this configuration, I am confused to whether they are backwards.
I was unaware they would not interchange from left to the right. I worked on SBC to long, this is my first LS engine.
I am using the LS3 intake.
Needing some ideas.
