clutch problems
Thread Starter
Race Director
Joined: May 2015
Posts: 13,175
Likes: 129
From: Louisiana
St.. Jude Donor '17-'18
IF,,, you actually press the male and female clutch line quick disconnect fittings together before you try to press in on the plastic ring, it makes the release a LOT easier! Once the white plastic release ring is fully depressed into the fitting, the male fittings will just pull apart from the female fitting.
I also usually spray WD-40 on the white plastic ring prior to working on it. I found a large open end wrench that would fit around the male fitting and properly contact the white ring. Work fantastic!
Bill
I also usually spray WD-40 on the white plastic ring prior to working on it. I found a large open end wrench that would fit around the male fitting and properly contact the white ring. Work fantastic!
Bill
