AC issue
Le Mans Master
Joined: Mar 2011
Posts: 6,835
Likes: 302
From: Columbia SC
Try this:
Re-Calibrating Actuators
Use the following steps to perform the calibration update:
1. Turn OFF the ignition.
2. Remove the battery positive voltage circuit fuse of the HVAC Control Module (fuse #27) in the passenger fuse box.
Important
The module memory will not clear if the battery positive voltage circuit fuse is installed in less than 60 seconds.
3. Wait 60 seconds.
4. Install the fuse.
This procedure reset the HVAC unit and must be done exactly as posted.
Re-Calibrating Actuators
Use the following steps to perform the calibration update:
1. Turn OFF the ignition.
2. Remove the battery positive voltage circuit fuse of the HVAC Control Module (fuse #27) in the passenger fuse box.
Important
The module memory will not clear if the battery positive voltage circuit fuse is installed in less than 60 seconds.
3. Wait 60 seconds.
4. Install the fuse.
This procedure reset the HVAC unit and must be done exactly as posted.
Thread Starter
Instructor
Joined: May 2015
Posts: 105
Likes: 5
From: Hayward California
Went back to shop that charged system 3 months ago. After checking and finding no leaks he was able to put more freon into system.Took a while to get a whole can in but when done both sides were blowing cold.
Thanks for the input and replies
MVZ
Thanks for the input and replies
MVZ
