LS1 to a LS6= p1635 code
Thread Starter
Instructor
Joined: Sep 2005
Posts: 220
Likes: 2
From: villa rica ga
LS1 to a LS6= p1635 code
I swapped a ls6 into a 2000 FRC. The previous LS1 was a built motor (heads,cam,headers)that lost an oil pump. The LS6 is basically stock except headers, intake. Can this cause the P1635 code? All is checking good, steering me to a pcm change. I was curious when I take it to get dyno tuned will this clear, or should I get a new pcm? Car cranks up fine and drives good, it will backfire maybe once in a 10-15 mile drive.
Thanks,
Bill R.
Thanks,
Bill R.
Melting Slicks
Joined: Jun 2002
Posts: 2,246
Likes: 66
From: Middletown CT
The MAP sensor, oil pressure sensor and right and left fuel level sensors all use the same 5V reference. Maybe a wire shorted to voltage or ground?
Here is the troubleshooting procedure most of which you can check with a DMM.
Here is the troubleshooting procedure most of which you can check with a DMM.
Last edited by Greg_E; Apr 22, 2017 at 07:31 PM.
Thread Starter
Instructor
Joined: Sep 2005
Posts: 220
Likes: 2
From: villa rica ga
Thanks Greg!! I have checked power to all sensors through the pcm to ground with engine running, all checked good. I guess I need to check with key on, engine not running and the voltage at pcm. Will check back in with results.
Thanks,
Bill R.
Thanks,
Bill R.
