Ignition Switch Question
#1
Ignition Switch Question
There are two Battery voltage pins shown on the ignition switch one on connector C1 (circuit 1442) & C2 (circuit 1542) both Pin A can anyone explain the difference in them.
Thanks in advance
Thanks in advance
Last edited by tentuna; 01-29-2018 at 12:54 PM.
#2
Safety Car
Red feed wire #1542 is for the Yellow wire (start circuit power) and Orange wire (ignition run circuit power). Red feed wire #1442 is for the Purple wire (ignition start circuit power) and Brown wire (accessory circuit power). Red wire #1542 is fed from Maxifuse 48 (60A) and Red wire #1442 is fed from Maxifuse 45 (60A); both are hot at all times. The ignition switch connects the load circuit wires to the red feed wires.
The following users liked this post:
tentuna (01-30-2018)
#3
Tech Contributor
Member Since: Dec 1999
Location: Anthony TX
Posts: 32,736
Received 2,180 Likes
on
1,583 Posts
CI 6,7,8,9,11 Vet
St. Jude Donor '08
Just splits the loads:
BC
BC
The following users liked this post:
tentuna (01-30-2018)