O2 abs traction control
Thread Starter
1st Gear
Joined: Sep 2022
Posts: 1
Likes: 0
O2 abs traction control
I took my 02 out a for a walk the other day, After driving about 30 minutes I made a stop. When I restarted the car I got SERVICE ABS AND TRACTION CONTOL message. After the car set over night, I started it up and the message was gone. ABS warning syestem went back to normal. Question for the group has anyone else had this problem? If so was it the ECBM or a wire seperating after getting warm. I cleaned all the grounds today but weather did not permit another drive. When I ran the codes I got C1214
Instructor
Joined: May 2008
Posts: 174
Likes: 45
From: Pahrump NV.
Instructor
Joined: Jan 2022
Posts: 154
Likes: 31
From: Temecula, CA
Ebcm.
It will progressively start happening on a more consistent basis. There are YouTube videos on how to remove the module, how to get the case open and how to reflow/resolder. If you don't feel comfortable with the last 2 steps, shoot me a PM.
It will progressively start happening on a more consistent basis. There are YouTube videos on how to remove the module, how to get the case open and how to reflow/resolder. If you don't feel comfortable with the last 2 steps, shoot me a PM.
