Brake Bleeding Issue
Thread Starter
Drifting
Joined: Aug 2007
Posts: 1,846
Likes: 129
From: Orlando Florida
Brake Bleeding Issue
Just installed C6Z brakes on my 2000 FRC and the ABS and service traction control lights and warnings are still on after running 32 oz of brake fluid through the lines but is it possible there is still air trapped in the system as the pedal isnt as good as it was plus on hard braking the right rear always locks up. The reservoir was never low so I cant imagine the ABS module has air in it. I plan on driving it more and then bleeding the brakes again but wondered if anyone else ran into this. I do not have a Tech2 scanner either. Thanks in advance
Drifting
Joined: Sep 2009
Posts: 1,862
Likes: 595
From: Prescott, Arizona
Check codes and the following thread; got a c1247?
https://www.corvetteforum.com/forums...activated.html
https://www.corvetteforum.com/forums...activated.html
Thread Starter
Drifting
Joined: Aug 2007
Posts: 1,846
Likes: 129
From: Orlando Florida
Check codes and the following thread; got a c1247?
https://www.corvetteforum.com/forums...activated.html
https://www.corvetteforum.com/forums...activated.html
