Removing upper shell from FAST 102 intake
Thread Starter
Burning Brakes
Joined: Mar 2003
Posts: 915
Likes: 1
From: UK
Removing upper shell from FAST 102 intake
Is it possible to remove the upper shell on this intake without pulling the intake off the motor? Do the same bolts used for mounting the intake to the valley also secure the upper shell? It's not obvious by just looking at the intake. Thanks.
Le Mans Master
Joined: Jun 2016
Posts: 5,436
Likes: 3,991
From: Cincinnati, OH
LS intake removal is one of the easiest to do...
Unplug coil packs
Disconnect fuel line
Disconnect air bridge
Remove intake bolts
remove intake.
This should take no more than 30min.
Tech Contributor
Joined: Dec 1999
Posts: 32,910
Likes: 2,402
From: Anthony TX
CI 6,7,8,9,11 Vet
St. Jude Donor '08
LOL! Plus, resealing it to the lower shell will be damn near impossible or at least very difficult to do it properly.
Its hard enough to do properly when its off the vehicle let alone on the vehicle.
Its hard enough to do properly when its off the vehicle let alone on the vehicle.
