Need help. Check engine light
Thread Starter
Le Mans Master
Joined: Dec 2001
Posts: 5,140
Likes: 0
From: Miami FL
St. Jude Donor '03-'06-'07-'08
Need help. Check engine light
I installed the powerduct along with the relocated MAT sensor. Then I got check engine light. I pulled the codes and came up with p1112 intake temp (IAT) sensor circuit intermittent low voltage - c and p0112 intake air temp (IAT) sensor circuit low voltage -B
I installed the fuel pressure regulator line in the same line as the new/relocated mat sensor. Could this pose a problem?
Please look at my first post too http://forums.corvetteforum.com/zerothread?id=489825
Thanks
I installed the fuel pressure regulator line in the same line as the new/relocated mat sensor. Could this pose a problem?
Please look at my first post too http://forums.corvetteforum.com/zerothread?id=489825
Thanks
Race Director
Joined: Aug 1999
Posts: 15,466
Likes: 0
From: GARDENA Ca, State Of Konfusion
St. Jude Donor '05
Re: Need help. Check engine light (JeffsVette)
Remove the MAT Sensor and see if the code goes away, it my be defective. That craq did not work for me on my Y2K, cause me a lot of knock retard. Sold it! The IAT and the MAT are the same thing.
[Modified by wallstAL, 6:02 PM 2/9/2003]
[Modified by wallstAL, 6:02 PM 2/9/2003]
Thread Starter
Le Mans Master
Joined: Dec 2001
Posts: 5,140
Likes: 0
From: Miami FL
St. Jude Donor '03-'06-'07-'08
Re: Need help. Check engine light (wallstAL)
I removed the wire only. Same thing, engine light came on. However I do think it is the wire. I will bring it byBreathless tomorrow. Thanks a lot.
