Need torque tube install help
Instructor
Joined: Apr 2021
Posts: 248
Likes: 91
From: Mobile
Keep in mind that you need to compress the slave cylinder the last inch or so. Think about it. It'll go in smooth then stop a bit less than an inch away when the TOB meets the clutch PP fingers. Get it squared up as best as you can and get the TT to bellhousing bolts started. You should be able to draw the TT in using the bolts. But it it takes too much effort, STOP because something isn't lined up. It should draw in easily with the bolts.
Advanced
Joined: Mar 2006
Posts: 84
Likes: 5
From: Bowling Green KY
When using a plastic alignment tool put a tiny amount of upward pressure (very small amount) before tightening pressure plate bolts. I finally bought a metal Tick alignment tool. I feel like it does a much better job. Or maybe you could use a scrap input shaft for alignment if you have one available.
Thread Starter
Racer
Joined: May 2005
Posts: 276
Likes: 0
From: Sandpoint, Idaho
Thanks guys. I got some longer bolts and pulled it in. The drive train is in. Almost there!
I disconnected the brakw lines feom the calipers. Anyone have a picture of how the lines run?
I disconnected the brakw lines feom the calipers. Anyone have a picture of how the lines run?
