Instruction on how to??
Pro
Joined: Jan 2002
Posts: 741
Likes: 9
From: Rancho Cordova CA
Re: Instruction on how to?? (hrdtopv8)
You can go to Lingenfelters page and download the MagnaChager instructions. It has a whole page on pinning the crank. I had my crank and balancer keyed. It was done with the crank out of the car. There is a tool the makes the grind into the crank. Not sure if it can be done on the car, there is a reluctor gear on our crank that makes it hard to get to without the correct tool. :cheers: :cheers:
Drifting
Joined: Jul 2002
Posts: 1,320
Likes: 0
From: Duncanville Texas
Re: Instruction on how to?? (Steve'01)
Did mine on the car. After removing the steering rack and moving the power steering cooler there was no problem.
Also a right angle dewalt drill was used (18V)!!!!!
Also a right angle dewalt drill was used (18V)!!!!!
Thread Starter
Pro
Joined: Feb 2001
Posts: 685
Likes: 0
From: Somewhere in the Mid West
Re: Instruction on how to?? (z0sense)
Did mine on the car. After removing the steering rack and moving the power steering cooler there was no problem.
Also a right angle dewalt drill was used (18V)!!!!!
Also a right angle dewalt drill was used (18V)!!!!!
Any chance you have instructions on how you did it? :confused:
Drifting
Joined: Jul 2002
Posts: 1,320
Likes: 0
From: Duncanville Texas
Re: Instruction on how to?? (hrdtopv8)
no instructions, but if you ise jmx's "howto" page it will show you how to move the rack, etc! (he shows it in his cam swap section!
I believe the site is
http://www.ls1howto.com
:cheers:
I believe the site is
http://www.ls1howto.com
:cheers:
