Computer Codes how do i reset
Thread Starter
2nd Gear
Joined: Jun 2003
Posts: 2
Likes: 0
Computer Codes how do i reset
I have a few codes showing up on when i do a manual computer code check, how do i reset them without using a tech 2 ??? i have a 2000 vette 6 spd and had a a/c leak that soaked my bcm. thanks for the info, this site is great!!!!
Safety Car
Joined: Sep 2001
Posts: 4,411
Likes: 1
From: Wilmington NC
Re: Computer Codes how do i reset (Duroman)
I have a few codes showing up on when i do a manual computer code check, how do i reset them without using a tech 2 ??? i have a 2000 vette 6 spd and had a a/c leak that soaked my bcm. thanks for the info, this site is great!!!!
Intermediate
Joined: Jun 2003
Posts: 37
Likes: 0
From: bakersfield ca
Re: Computer Codes how do i reset (Duroman)
1. Turn key on but don't start car.
2. Pull PCM BAT and PCM IGN fuses in engine compartment.
3. Wait a few minutes.
4. Turn ignition off.
5. Replace fuses.
It will take the car a while to relearn the fuel and timing curves so don't worry about a temporary performance loss.
2. Pull PCM BAT and PCM IGN fuses in engine compartment.
3. Wait a few minutes.
4. Turn ignition off.
5. Replace fuses.
It will take the car a while to relearn the fuel and timing curves so don't worry about a temporary performance loss.
Le Mans Master
Joined: Jul 2002
Posts: 7,370
Likes: 8
From: Slave to the evil empire
Cruise-In V Veteran
St. Jude Donor '04
Re: Computer Codes how do i reset (Duroman)
It's very simple, after your car goes thru all of the computers and codes it goes into "manual diagnostics" once there you will see for example
"PCM - 1 code" once that comes up just push and hold the "reset" button and you can watch it go to "PCM - 0 codes" :cheers:
"PCM - 1 code" once that comes up just push and hold the "reset" button and you can watch it go to "PCM - 0 codes" :cheers:
Thread Starter
2nd Gear
Joined: Jun 2003
Posts: 2
Likes: 0
Re: Computer Codes how do i reset (Duroman)
What is the difference between disconnecting the battery and pulling those fuses?? Are those fuses by the bcm? I have tried to reset the codes from the ipc but they are still there, does that me there current codes even if the show history codes?
