shift boot
Thread Starter
Instructor
Joined: Jan 2004
Posts: 180
Likes: 0
From: Woodbridge Virginia
shift boot
I am going to shorten my shifter. Before I go start taking the cosole apart . Does anyone know if the shift boot just pops off? Or do I have to remove the consloe?
Melting Slicks
Joined: Aug 2003
Posts: 2,406
Likes: 0
From: Fly Over State
Senior Member
Cruise-In V Veteran
Re: shift boot (HIGHRPM)
It has clips around the inside edge.....push down gently and it comes right out.....but since your changing the shifter the console has to come out anyway. :cheers:
[Modified by ALLKAR, 11:34 PM 1/10/2004]
Le Mans Master
Joined: Aug 2002
Posts: 8,222
Likes: 0
From: Norfolk VA
Re: shift boot (ALLKAR)
It has clips around the inside edge.....push down gently and it comes right out.....but since your changing the shifter the console has to come out anyway. :cheers:
:iagree: You have to remove the **** TOO.
[Modified by ALLKAR, 11:34 PM 1/10/2004]
:iagree: You have to remove the **** TOO.
[Modified by ALLKAR, 11:34 PM 1/10/2004]
good luck
Edit: these might help https://www.corvetteforum.com/techti...D=34&TopicID=1 https://www.corvetteforum.com/techti...D=28&TopicID=1
[Modified by Lancer033, 2:00 AM 1/11/2004]
Thread Starter
Instructor
Joined: Jan 2004
Posts: 180
Likes: 0
From: Woodbridge Virginia
Re: shift boot (Lancer033)
Thanks for thew help guys. I was going to try this http://joshker99.home.comcast.net/shifterpage.htm
but Im opting against it. Im gonna either go with the breathless performance or the B&M. And youre right on the vette essentials site they give dirsctions on how to remove console and shifter and they say its really hard to remove the **** but it took me like 30 seconds. There is a little lip on the key you can just get a good size flathead and pry it out. :skep:
but Im opting against it. Im gonna either go with the breathless performance or the B&M. And youre right on the vette essentials site they give dirsctions on how to remove console and shifter and they say its really hard to remove the **** but it took me like 30 seconds. There is a little lip on the key you can just get a good size flathead and pry it out. :skep:
