LT Header Install Question... HELP!!!
Thread Starter
Heel & Toe
Joined: May 2002
Posts: 18
Likes: 0
From: CA
LT Header Install Question... HELP!!!
Installed the Supermaxx LT headers and B&B catback today, but ran into an issue with securing the O2 sensor wiring harnesses on both sides. Does anyone have any tips on how to tie these harnesses up so they are not resting on the pipes? I cannot find an area that is suitable.
Thanks in advance.
Thanks in advance.
Drifting
Joined: Sep 2002
Posts: 1,614
Likes: 7
From: South Florida
Re: LT Header Install Question... HELP!!! (HMSC5)
not sure about the supermax system, but I did the LG system.
I drilled a 1" hole in the torque tube cover, stuck a grommet in it and ran the sensors above that. I ziptied the wires to crap as the climbed up the firewall. I tied to brake lines on driver's side, and I forget where on the passenger side. Don't know if that helps your headers.
I drilled a 1" hole in the torque tube cover, stuck a grommet in it and ran the sensors above that. I ziptied the wires to crap as the climbed up the firewall. I tied to brake lines on driver's side, and I forget where on the passenger side. Don't know if that helps your headers.
