Dynatech install
Thread Starter
Pro
Joined: Jun 2003
Posts: 702
Likes: 0
From: Castle Rock Co
Dynatech install
Just wrapped up the hardware install last night, still need to tighten clamps and route the o2 wires.
Just a word of advice for anyone considering these headers. Unless you have a lift, forget installing the drivers side from below. I fussed with it for 2 hours, (I'm not new at this) and could not get the car high enough for them to go in. I finally pulled the valve cover and steering shaft (took about 5 min) and the header literally fell in from the top.
Just a word of advice for anyone considering these headers. Unless you have a lift, forget installing the drivers side from below. I fussed with it for 2 hours, (I'm not new at this) and could not get the car high enough for them to go in. I finally pulled the valve cover and steering shaft (took about 5 min) and the header literally fell in from the top.
