Show Your Creative Low Cost or No Cost DIY Corvette Projects (Pics if Poss.)
The following users liked this post:
Boxcar (08-12-2017)
#23
Safety Car
#24
For those that like to take their tops off their targa, you may notice some wear or tears forming on the small leatherette pieces on the front top if you haven't been careful.
I used some door edge guard material cut to size to protect the edges.
I usually place my targa top down and instead of forcing it, I grab the rear latch to pull the targa back and down into place instead of trying to wedge it back in from the front or from the outside. If you have it adjusted just right, you can get the hook to catch at the back then use the latch to get it all into place.
I used some door edge guard material cut to size to protect the edges.
I usually place my targa top down and instead of forcing it, I grab the rear latch to pull the targa back and down into place instead of trying to wedge it back in from the front or from the outside. If you have it adjusted just right, you can get the hook to catch at the back then use the latch to get it all into place.
The following users liked this post:
madmatt9471 (08-13-2017)
The following users liked this post:
madmatt9471 (08-13-2017)
#27
Burning Brakes
The following users liked this post:
HammerheadTed (08-13-2017)
#29
Race Director
Pro Mechanic
Member Since: Apr 2014
Location: Washington Township Michigan
Posts: 14,521
Received 3,952 Likes
on
2,470 Posts
2024 Corvette of the Year Finalist - Unmodified
2023 C6 of the Year Winner - Unmodified
2020 C6 of the Year Finalist - Unmodified
2019 C6 of Year Finalist (appearance mods)
below is a link to an older prior posted discussion with a lot of good ideas in it for the DIY'ers here................
https://www.corvetteforum.com/forums...-stuff-c6.html
https://www.corvetteforum.com/forums...-stuff-c6.html
#30
The issue with these is they don't compress enough to slide completely underneath a lowered car.
#31
I picked up these parts from a semi truck parts store.
2 air bags # W01-358-7705
3/8 plastic air line
3/8 instant push on fittings
on/off petcock valve
air chuck nipple
2x3 tube to slide over the air fitting
I plan on modifying the steel tube to use the lifting puck locations on the Vette.
The following 4 users liked this post by Cockroach:
#32
Team Owner
Thread Starter
Thanks for all the responses thus far!
Thanks,Matt
Thanks,Matt
#33
Burning Brakes