codes
#1
Advanced
Thread Starter
codes
I bought a chineese obd tech11 to help with my problems. Problem is, How to get started. Does anyone know how to get an 05 convertible on the thing and run diagnostics? I have been going through pages and pages of the manual (online) mostly about setup. I'm not finding how you get your specific vehicle in there.
I need to check on "service active handling system and service ABS system" notifications on the dash.
Any help on how to use one of these things would be greatly appreciated.
Thanks,
Jim
I need to check on "service active handling system and service ABS system" notifications on the dash.
Any help on how to use one of these things would be greatly appreciated.
Thanks,
Jim
#2
In tech2win from the blue screen and it connected to the OBDII port below the steering wheel to connect it to the car,
press enter
F0 diagnostics,
2005 for the year of car,
passenger car
Chevrolet
Y body car
F0 VCS
enter trans type
Enter a few more times for the two other screens,
Then F0 to pull the DTC's
press enter
F0 diagnostics,
2005 for the year of car,
passenger car
Chevrolet
Y body car
F0 VCS
enter trans type
Enter a few more times for the two other screens,
Then F0 to pull the DTC's
#3
Safety Car
Member Since: Dec 2006
Location: Pearland / Houston Tx
Posts: 3,760
Likes: 0
Received 1,119 Likes
on
694 Posts
The manual was too big to print for me. But I did print a hard copy of the menu paths in the device,
See post #5 in this thread.....https://www.corvetteforum.com/forums...u-listing.html
See post #5 in this thread.....https://www.corvetteforum.com/forums...u-listing.html