zr1 hood
10-28-2016, 07:50 PM
#1
Instructor
Thread Starter
zr1 hood
ACS fiberglass zr1 hood with oem window hood has only been on the car for 6 months paint still looks new. looking to get. Sold
Last edited by Jetblackc6; 10-30-2016 at 06:22 PM. Reason: Sold
10-29-2016, 01:02 AM
#6
Instructor
Thread Starter
10-29-2016, 07:45 AM
#7
Emerging Vendor
great seller...btw....acs stopped making this hood...this is a great buy
Last edited by Smokeyjr; 10-29-2016 at 08:13 AM.
The following users liked this post:
Jetblackc6 (10-29-2016)
10-30-2016, 12:43 AM
#10
Instructor
Thread Starter
10-30-2016, 08:48 AM
#12
Emerging Vendor
Works for me!!...i have one on my vet...I am telling you...this is a great price
10-30-2016, 09:09 AM
#13
10-30-2016, 09:15 AM
#14
Emerging Vendor
i have a kit that i made that adapts the acs louver or the polycarbonate window to the hood ...here you go!...I actually had my vete at Road America on the track...no issues with heat
Last edited by Smokeyjr; 10-30-2016 at 09:29 AM.
10-30-2016, 09:35 AM
#15
Emerging Vendor
there are "no" issues with the hood fitting on top of a stock ls motor..or a factory supercharged motor...base c6/zr1/z06/gs..this is a supercharger hood...so the clearance in the center section is taller...also the bracing at the inside back is different "better" than some others...this hood will accommodate a eforce supercharger with no problem...or a zr1 supercharger...thats just for future use...acs is noted for their quality products
Last edited by Smokeyjr; 10-30-2016 at 09:41 AM.
10-30-2016, 09:40 AM
#16
Drifting
To give you folks an idea of what the vented insert looks like I have attached a couple of pictures of my hood
In my case I used the factory epoxy to attach the acs vented insert but the epoxy can be cut to remove the vent or the window.
Smoky has a slick set up if you want to switch back and fourth
In my case I used the factory epoxy to attach the acs vented insert but the epoxy can be cut to remove the vent or the window.
Smoky has a slick set up if you want to switch back and fourth
10-30-2016, 09:56 AM
#17
Thanks for all the pics.. great looking vette! I'm just stuck on how dumb it will look just looking down into a stock ls3 motor without a supercharger. Where did you get the louvers/vents.
10-30-2016, 09:58 AM
#18
Drifting
https://acscomposite.com/collections...ster-zr1-hoods
10-30-2016, 10:13 AM
#19
Emerging Vendor
Thanks 1968!!...this is the underside...i attached some expansion nuts as rubber bumpers...and rubber washers to keep a tight seal on the louver...do I need them...no...it's better looking
Last edited by Smokeyjr; 10-30-2016 at 10:17 AM.