Anybody running an AFR500 connected to HPT?
#1
Anybody running an AFR500 connected to HPT?
I have my wideband installed but I dont know how to go about adding the signal to my MPIV. I searched it on HPTforums but maybe im a little dense haha.
#3
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,194 Likes
on
1,053 Posts
St. Jude Donor '15
It's two wires. A 0-5V output (yellow wire) and a ground wire (black with white stripe). Not hard.. Connect 0-5V+ wire to pin 1 on HPTuners interface, connect ground to pin 5 or 6.
Follow this for setting it up in Scanner:
http://www.hptuners.com/forum/showth...-PRO-Interface)
https://www.hptuners.com/forum/showt...tarted-Threads
And you're done
Follow this for setting it up in Scanner:
http://www.hptuners.com/forum/showth...-PRO-Interface)
https://www.hptuners.com/forum/showt...tarted-Threads
And you're done
Last edited by schpenxel; 07-08-2017 at 09:07 PM.