Alot of ponies.
MTI Supercharged...
Thread Starter
Melting Slicks
Joined: Nov 2002
Posts: 2,289
Likes: 29
From: Pearland Tx
MTI Supercharged...
I would like to first say "thanks" to Jayson,David and Chris at MTI in Houston,Texas for a job well done on my 2005 C6 M6 Z51.
I had a D1 Procharger,cam kit,headers,60lb Motron injectors and LS2 edit with a wideband tune done by them.
Well on the first run it put down 363rwhp / 360rwtrq not bad for stock!
After the install it was back to the dyno and bam 600rwhp / 510rwtrq.
Jayson then did a little fine tuning and was able to pull it to
614rwhp / 524rwtrq.
That was good but I had plans of installing a "Snow Performance" alky injection kit on it also to keep it safe on summer days .I installed it and also a KB Boost-a-Pump just to be on the safe side.
So back to the dyno it went for retuning and the end results where amazing
657rwhp / 592rwtrq at 9lbs of boost.
Corrected numbers are 645rwhp / 581rwtrq
Thanks to MTI for a job well done and if you are interested in a Supercharger I would highly suggest you call MTI in Houston,TX
I had a D1 Procharger,cam kit,headers,60lb Motron injectors and LS2 edit with a wideband tune done by them.
Well on the first run it put down 363rwhp / 360rwtrq not bad for stock!
After the install it was back to the dyno and bam 600rwhp / 510rwtrq.
Jayson then did a little fine tuning and was able to pull it to
614rwhp / 524rwtrq.
That was good but I had plans of installing a "Snow Performance" alky injection kit on it also to keep it safe on summer days .I installed it and also a KB Boost-a-Pump just to be on the safe side.
So back to the dyno it went for retuning and the end results where amazing
657rwhp / 592rwtrq at 9lbs of boost.Corrected numbers are 645rwhp / 581rwtrq
Thanks to MTI for a job well done and if you are interested in a Supercharger I would highly suggest you call MTI in Houston,TX
Drifting
Joined: Nov 2005
Posts: 1,322
Likes: 3
From: Hugetown Texas
St. Jude Donor '06-'07
Originally Posted by jschindler
I've known Jayson for quite a while, and I agree that MTI is first class.
Melting Slicks
Joined: Nov 2003
Posts: 2,312
Likes: 82
From: Ridgeland MS
St. Jude Donor '06-'07-'08-'09-'10-'11
WOW - Good numbers. Now you need to get out of that Houston traffic to let 'er rip. Did you do anything to strenghen the bottom end also what about the rear end? How does it drive with this set-up?
Bill
Did you do anything to strenghen the bottom end also what about the rear end? How does it drive with this set-up? Bill
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Every 2027 Corvette Engine Explained
Joe Kucinski
Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette
Verdad Gallardo
10 Ugly Corvettes That We Still Kinda Love
Joe Kucinski
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
