what happens if...
Thread Starter
Melting Slicks
Joined: May 2005
Posts: 2,231
Likes: 0
From: Brownsville Tx
what happens if...
I recently installed a set of LG headers with catted x-pipe on my C6. I was just sittin here thinkin about it and it dawned on me that I may have installed the sensors by the cats wrong. Since they come crossed out of the X-pipe, i think I just ran them in the direction they were going. What will this affect, or can I just leave them?
Le Mans Master
Joined: Dec 2002
Posts: 7,588
Likes: 6
From: Montreal Qc
If you did reverse them and the car ran completely perfect, probably nothing....but cars do not run completely perfect, so now the computer will try to adjust something to the left bank (for example) and it will expect to see a change at the sensor, but it won't because they are reversed. You will then get a ckeck engine light and the car will likely not run as well as it should. That's what I think.
Don't sweat it though, it's not too hard to correct your error.
Don't sweat it though, it's not too hard to correct your error.
