When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
OK, I changed my Supercharger pulley yesterday to 3.10" (was 3.40") and I didn't change the belt, installed LPE S\C CAI too.
Problem is the car wont run for one mile, suddenly shut down! The "Reduced Engine Power" light appear! I didn't tune the car for the new pulley or for the new CAI yet.. what do you guys think is the main problem? and I'm getting a new exhaust system, so do I need a tune for the new exhaust too? I can use all the help you offer.
Thanks!
Last edited by LS2-Zomb!e; May 15, 2007 at 02:51 PM.
Predicted air table needs to be raised most likely, see your tuner.
Doug, do you mean the air flow is not enough? What about the exhaust? do I need a tune for it? can't the problem caused from the smaller new pulley hooked up with the old belt?
Last edited by LS2-Zomb!e; May 15, 2007 at 07:22 PM.
OK, I changed my Supercharger pulley yesterday to 3.10" (was 3.40") and I didn't change the belt, installed LPE S\C CAI too.
Problem is the car wont run for one mile, suddenly shut down! The "Reduced Engine Power" light appear! I didn't tune the car for the new pulley or for the new CAI yet.. what do you guys think is the main problem? and I'm getting a new exhaust system, so do I need a tune for the new exhaust too? I can use all the help you offer.
Thanks!
LPE CAI uses a 100mm MAF so it will not run right! GO TUNE IT PLEASE!