Telescoping wheel problem.
Thread Starter
Advanced
Joined: Jun 2002
Posts: 79
Likes: 0
From: Marion IL
Telescoping wheel problem.
I have a 2007 conv. and last week I went to start it and the battery was dead and it wouldn't start. I popped the hood and the positive terminal had a lot of green junk on it so I removed it from the battery post and cleaned it well. I reinstalled it on the battery and put a charger on the battery. The next day I checked and the battery was charged and all appeared ok. When I started the car I noticed the telescoping wheel did not extend. I did a search on the forum and read that you can reset it by moving the switch in or out several times until it starts to work again. I have tried this several times on several days but it still doesn't move. Any ideas before I make a trip to the shop? Thanks in advance.
Team Owner
Joined: Apr 2005
Posts: 35,760
Likes: 148
From: Northern NYs Adirondack Mountains,http://www.visitsacandaga.com.
You can try disconnecting the battery for a few minuets’ and then hooking it up again. Sort of a C6 computer reboot.
You did not mention windows, did they work ok or did you have to reindex?
You did not mention windows, did they work ok or did you have to reindex?
Thread Starter
Advanced
Joined: Jun 2002
Posts: 79
Likes: 0
From: Marion IL
When I tried to start the car with the dead battery the windows went down about 1 inch and stopped. ( without moving the window button ) when I started the car after charge I raised them and they are now working ok . I will try and disconnect the battery again and see if that helps. Thanks for the input.
Team Owner
Joined: Apr 2005
Posts: 35,760
Likes: 148
From: Northern NYs Adirondack Mountains,http://www.visitsacandaga.com.
