C6 window switch panel prolem
Thread Starter
Heel & Toe
Joined: Jan 2010
Posts: 23
Likes: 0
From: Fleming Island Florida
C6 window switch panel prolem
I have a 2006 with an annoying issue. When I pull up on either window switch on the drivers door, the entire back end of the switch panel lifts out of the arm rest. The front or pointed end stays in place. Also, when I close the door, something light and metallic rattles inside. It is not a clunk or anything heavy. Could a metal clip have come off the switch panel? I know there is one under the front pointed end but am not sure what holds the rear section in? 
Thread Starter
Heel & Toe
Joined: Jan 2010
Posts: 23
Likes: 0
From: Fleming Island Florida
I saw a picture of a used one on EBAY. Does the clip fit into a groove on the side of the bottom of the switch? How hard is it to get the door panel off and do I need any special tools?
Supporting Vendor
Joined: Sep 2007
Posts: 11,216
Likes: 178
From: Pensacola Florida GO GATORS!!! www.rlsebring.com www.c6c7vette.com
St. Jude Donor '17
Panels not hard to remove but are noisy and sound like it's going to break while removing. Look over in the audio section and search door panels. Several write ups that will walk you through it.
