CCP/HKE LS3 416 an 427 Engine Pricing
12-04-2010, 11:49 AM
#42
Drifting
Any LS2 pricing yet?
$3675 add $1150 for the block if you dont supply one. All the same upgrades apply.
12-25-2010, 08:39 PM
#45
Burning Brakes
Member Since: Aug 2007
Location: SPRING HILL FL
Posts: 962
Likes: 0
Received 0 Likes
on
0 Posts
What combo do I need to get in to the low 10's and still have street manners. I have an 08 with A6, going with a 3:15 or 3:42 gear. I can get 600 WRHP with a E-force, cam, headers. I like a NA setup a little better, Not as much worry about heat, I live in Fla. PM me with some packages. It's still Christmas for 3 1/2 hours.
01-26-2011, 12:33 PM
#54
Former Vendor
Thread Starter
Member Since: Apr 2006
Location: Portland OR
Posts: 2,470
Likes: 0
Received 1 Like
on
1 Post
St. Jude Donor '10-'11-'12
It all depends on how its cammed and if we touch up the heads a bit but typically see anywhere from 500-550 on a 408 and we're adding 8 cubic inches to that.
02-24-2011, 10:59 AM
#58
Former Vendor
Thread Starter
Member Since: Apr 2006
Location: Portland OR
Posts: 2,470
Likes: 0
Received 1 Like
on
1 Post
St. Jude Donor '10-'11-'12
Its for the long block... $6600
This is a quick breakdown of it:
The short is Callies crank and rods, Wiseco pistons and GFX rings, Acl and Fed Mogul coated race bearings, ARP mainstuds. We port and polish your heads, put new springs and retainers on. New cam, double roller timing set, Morel link bar lifters, Melling Hv oil pump, Hke hardened pushrods and ARP head bolts, rebuild of your rockers make up the top end.
This is a quick breakdown of it:
The short is Callies crank and rods, Wiseco pistons and GFX rings, Acl and Fed Mogul coated race bearings, ARP mainstuds. We port and polish your heads, put new springs and retainers on. New cam, double roller timing set, Morel link bar lifters, Melling Hv oil pump, Hke hardened pushrods and ARP head bolts, rebuild of your rockers make up the top end.
