Dyno results
Thread Starter
Instructor
Joined: Apr 2011
Posts: 166
Likes: 2
Dyno results
Greetings everyone
Finally getting around to posting my dyno results. I have a manual 2007 Z51. Mods are minimal : Airaid intake, ported intake and tb, Borla Stinger Catback. For being here at elevation in Denver, I think the results were good.I still need to get out to Bandimere to see what she will put down in the qtr mile. Now getting ready to pull the trigger on a cam and LT's.
Dynojet model 248c
SAE HP 372.8
Torque 366.0
Finally getting around to posting my dyno results. I have a manual 2007 Z51. Mods are minimal : Airaid intake, ported intake and tb, Borla Stinger Catback. For being here at elevation in Denver, I think the results were good.I still need to get out to Bandimere to see what she will put down in the qtr mile. Now getting ready to pull the trigger on a cam and LT's.
Dynojet model 248c
SAE HP 372.8
Torque 366.0
Melting Slicks
Joined: Dec 2006
Posts: 2,186
Likes: 2
From: Woodinville WA
Thats the beauty of SAE numbers. With proper correction it should be fairly consistent regardless of environmental factors. Your SAE numbers are most likely higher than your non corrected numbers because of your location.
