Hurst short throw shifter
Thread Starter
Intermediate
Joined: Feb 2014
Posts: 41
Likes: 2
From: Lafayette CA.
Hurst short throw shifter
I recently replaced the stock shifter on my "08 Z51 vert with a Hurst Short throw shifter and it shifts nice and tight; the problem is when you accelerate hard in gears 2 to 5 you get a rattling noise that I didn't have withe stock unit. Hurst says thats normal because their unit is not plastic and you hear the vibration from the metal to metal contact. Anyone have any thoughts on this? I like the tightness but not the rattle.
Team Owner
Joined: Sep 2005
Posts: 20,352
Likes: 568
From: Ventura County, Calif
Race Director
Joined: Dec 2013
Posts: 12,505
Likes: 3,634
No damper on the Hurst shifter and why you are hearing the rattle.
Take a good look at the OEM shifter and notice that even it has a damper on it to keep if from rattling (the bell shape at the bottom).
Even B&M was smart enough to install a damper on it shifter so it did not rattle.
Bluntly, should have went with a MGW shifter from the start, since you will end up with it in the end. Not only does it have a damper to keep it from rattling, but smooth clean smooth short shifts, and rebuild-able (including the lower box) if needed as well.
Take a good look at the OEM shifter and notice that even it has a damper on it to keep if from rattling (the bell shape at the bottom).
Even B&M was smart enough to install a damper on it shifter so it did not rattle.
Bluntly, should have went with a MGW shifter from the start, since you will end up with it in the end. Not only does it have a damper to keep it from rattling, but smooth clean smooth short shifts, and rebuild-able (including the lower box) if needed as well.
Last edited by Dano523; Nov 23, 2014 at 01:06 AM.
