Line lock issue
Thread Starter
Instructor
Joined: Sep 2013
Posts: 193
Likes: 4
Line lock issue
Is it normal to do a burn out using line lock and the abs light and traction lights come on. I like to race with the abs active but I don't want to have to turn car off and back on to reset the bcm so the lights will go off.
Le Mans Master
Joined: Apr 2011
Posts: 7,820
Likes: 408
From: Montreal
St. Jude Donor '13
Can't help with the cause of the issue, but I can tell you my line loc never sets off my ABS light. I turn off the traction control when doing the burnout and racing though.
Safety Car
Joined: Jul 2009
Posts: 3,755
Likes: 190
From: Baton Rouge LA
St. Jude Donor '14, '16
See if it happens if you turn off both TC and AH by holding the button down. When my car was on the dyno it would throw all sorts of ABS lights if I just turned traction control off but left active handling on for some reason, and using linelock is a very similar situation for the car.
Last edited by sevinn; May 16, 2016 at 09:45 AM.
Safety Car
Joined: May 2011
Posts: 3,807
Likes: 508
From: Oshawa, Ontario
Thread Starter
Instructor
Joined: Sep 2013
Posts: 193
Likes: 4
I have a 2011 gs m6 and the line lock is coming st8 off the master cylinder goin to the bcm hot wire to hot side of alternator and ground ran in car to button . Do it sound like same way all y'all have it hooked up? It doesn't come on til after I have applied brakes and holding button. Wen I let off brakes and holding button the lights come on. I'm still at work so I haven't tried with the active handling and tc all off yet.
