Vent/catch can
Thread Starter
Pro
Joined: Feb 2008
Posts: 681
Likes: 65
Vent/catch can
Does anyone have a diagram of how I should route a naturally aspirated vent set up? It’s an LS3 motor that currently is pulling vacuum from the driver side valve cover to the intake and the passenger side is hooked to a long rubber hose that is tied to the transmission. Before you all say I should just go out and buy a catch can Mighty Mouse (I will be) or a elite engineering I was wondering if anybody had a diagram to help me further understand. Remember this is a naturally aspirated non-boosted application.
Thanks so much, Jason
Thanks so much, Jason
Racer
Joined: Nov 2013
Posts: 327
Likes: 29
From: San Diego CA
All the mighty mouse configurations are found on his site here:
Before installing my supercharger, I was running mine similar to the mild setup per his instructions.
https://drive.google.com/drive/mobil...13&direction=a
Before installing my supercharger, I was running mine similar to the mild setup per his instructions.
https://drive.google.com/drive/mobil...13&direction=a
Last edited by jetbluu; Aug 21, 2019 at 09:42 PM.
