Convertible peeps!
Thread Starter
Moderator emeritus
Joined: Jun 2001
Posts: 18,599
Likes: 3,951
From: Jacksonville Florida BWO Dayton, Cincinnati, Bloomsbury NJ, Cincinnati
2015 C7 of the Year Finalist
Convertible peeps!
The partition in the trunk that is raised to "reserve" space for the top is really disappointing. The center of the vertical snapping piece is sagging and bowing out. It looks like crap. Is it just my car or is this normal? My C6 partition was much sturdier and did bow at all and kept it's shape for the 7 years I owned the car.
With the sag I see now, the partition will hit the trunk floor in 7 years!
I'm thinking of making a hole for a "push-pin" to pull the center closer to the deck edge.
Any other ideas that you can think of?
Elmer
With the sag I see now, the partition will hit the trunk floor in 7 years!
I'm thinking of making a hole for a "push-pin" to pull the center closer to the deck edge.
Any other ideas that you can think of?
Elmer
Thread Starter
Moderator emeritus
Joined: Jun 2001
Posts: 18,599
Likes: 3,951
From: Jacksonville Florida BWO Dayton, Cincinnati, Bloomsbury NJ, Cincinnati
2015 C7 of the Year Finalist
Thread Starter
Moderator emeritus
Joined: Jun 2001
Posts: 18,599
Likes: 3,951
From: Jacksonville Florida BWO Dayton, Cincinnati, Bloomsbury NJ, Cincinnati
2015 C7 of the Year Finalist
It would be great to have the snap fitting that is on the driver side, also there in the center of the partition.
Thread Starter
Moderator emeritus
Joined: Jun 2001
Posts: 18,599
Likes: 3,951
From: Jacksonville Florida BWO Dayton, Cincinnati, Bloomsbury NJ, Cincinnati
2015 C7 of the Year Finalist
Velcro! All I needed to use was the hook side. It latched onto the partition and held it in place. Problem solved!
Thank you gentlemen!
Elmer
Thank you gentlemen!
Elmer
