Diff Fluid Drain Plug
Thread Starter
Racer
Joined: Oct 2012
Posts: 349
Likes: 1
From: Orange County CA
Diff Fluid Drain Plug
I can't for the life of me figure out where to order the special square bit needed for this diff fluid drain plug. Has anyone changed their own, and if so, what bit did you use? No Hex works, it's perfectly square.
E-Ray, 3LZ, ZER, LIFT
Joined: Sep 2007
Posts: 34,981
Likes: 12,383
From: NE South Carolina
However I am remined of the difficultly in removing the plug from my ’88 Vette Doug Nash 4+3 Trans. Tried to do it myself. Made a large Allen wrench from a 12 inch length ¾ inch hex stock heated cherry red two inches from one end and bent 90 degree in a vice (still have the tool.) Even with a section of pipe slipped over the end it didn’t budge. Car was still in warrantee so brought it to the dealer who had his mechanic try; it wouldn’t budge. He called his contact at Chevy and said he was worried about breaking the aluminum case. They said use a larger wrench! He brought it over the the truck repair bay. They used a very large wrench with a ¾ hex socket. I recall the noise when it finally broke lose. In sounded like a 44 Magnum being discharged! However, no cracks!
Last edited by JerryU; Apr 22, 2015 at 08:49 PM.
Usually a 3/8" ratch drive wrench or extension with the ratch drive wrench.
