A master reset function
Thread Starter
Racer
Joined: Nov 2013
Posts: 313
Likes: 44
From: Little Rock AR
A master reset function
Some may remember back when early ECU's with fuel injection started using dynamic maps & driver specific adjustments, one could always disconnect the battery, put a brick on the brake pedal, turn the hazards on, & duct tape the horn switch closed. Go to lunch then come back & remove everything, reconnect the battery give it a minute or two, then start it up. It would usually drive a lot better.
Does anyone know if this is possible on the 2014 C7? Without using an ECM programmer....
Wormwood
Does anyone know if this is possible on the 2014 C7? Without using an ECM programmer....
Wormwood
