Looking for a pin-out diagram
07-07-2019, 10:54 AM
#1
Melting Slicks
Thread Starter
Member Since: Jul 2010
Location: Between Tally and Gatorville ,Florida
Posts: 3,457
Received 84 Likes
on
70 Posts
Looking for a pin-out diagram
Anyone has a pin out diagram for the ecu on a 2014? Mine is a manual Z51 but any would help as I'm trying to locate power, ground and data pins. I have a ecu no comm issue code U0100
Last edited by Dale002; 07-07-2019 at 12:07 PM.
07-07-2019, 04:54 PM
#2
Melting Slicks
Member Since: Dec 2012
Location: St. Louis Metro East IL
Posts: 3,011
Received 1,304 Likes
on
863 Posts
Try poking around on this web site. Lots of good stuff. You'll have to register with them.
GL
Ron
http://www.bbbind.com/tsb-wiring-diagrams-database/
GL
Ron
http://www.bbbind.com/tsb-wiring-diagrams-database/
07-09-2019, 10:02 AM
#5
Le Mans Master
I've got it in my AllData account. I'll try to upload it around lunch time.
07-09-2019, 12:53 PM
#6
Le Mans Master
If this helps, buy an AllData DIY account. It's cheap.
07-13-2019, 08:20 AM
#7
Melting Slicks
Thread Starter
Member Since: Jul 2010
Location: Between Tally and Gatorville ,Florida
Posts: 3,457
Received 84 Likes
on
70 Posts
Jeff it does help Thank You. I did purchased a subscription to all data. I've also found the issue with the no comm ecu.
A rusted pin #4 at connector X100. Now I need to figure out how disassemble the connector to inspect other pins that may stated to rust and to replace the bad pin.
Then finding the correct pins on Mouser.
A rusted pin #4 at connector X100. Now I need to figure out how disassemble the connector to inspect other pins that may stated to rust and to replace the bad pin.
Then finding the correct pins on Mouser.